全自動攪拌車應遵守的操作規范
全自動攪拌車若不進行操作，將會引起翻車、液壓泵、馬達、減速機過快磨損甚出現嚴重后果，下面全自動攪拌車廠家根據使用全自動攪拌車應遵守的操作規范為大家作出了如下介紹。
If the full automatic mixer is not operated safely, it will cause overturning, hydraulic pump, motor, reducer to wear too fast or even have serious consequences. The manufacturer of the full automatic mixer has made the following introduction according to the safety operation specifications that should be followed when using the full automatic mixer.
1、拌筒的旋轉方向應符合箭頭指示方向，如不符實，應更正電機接線。
1. The rotation direction of the mixing drum shall conform to the direction indicated by the arrow. If not, the motor wiring shall be corrected.
2、全自動攪拌車應實施二級漏電保護，上班前電源接通后，仔細檢查，經空車試轉認為合格，方可使用。試運轉時應檢驗拌筒轉速是否合適，一般情況下，空車速度比重車(裝料后)稍快2~3轉，如相差較多，應調整動輪與傳動輪的比例。
2. The fully automatic mixer shall be provided with secondary leakage protection. After the power is turned on before going to work, it shall be carefully checked. It can only be used after passing the no-load trial run. During the test run, check whether the rotating speed of the mixing drum is appropriate. Generally, the speed of the empty car is 2~3 revolutions faster than that of the car (after loading). If there is a large difference, adjust the ratio of the driving wheel to the driving wheel.
3、攪拌車應設置在平坦的位置，用方木墊起前后輪軸，使輪胎擱高架空，以免在開動時發生走動。
3. The mixer truck shall be set at a flat position. Square wood shall be used to pad the front and rear axles, so that the tires are kept overhead to avoid walking when driving.
4、檢查傳動離合器和制動器是否靈活可靠，鋼絲繩有無損壞，軌道滑輪是否良好，周圍有無障礙及各部位的潤滑情況等。
4. Check whether the transmission clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the track pulley is in good condition, whether there are obstacles around and whether the lubrication of each part is good.
5、當混凝土攪拌完畢或預計停歇1h以上，除將余料出凈外，應用石子和清水倒入抖筒內，開機轉動，把粘在料筒上的砂漿沖洗干凈后全部卸出。料筒內不得有積水，以免料筒和葉片生銹。同時還應清理攪拌筒外積灰，使機械保持清潔完好。
5. When the concrete has been mixed or is expected to stop for more than 1h, in addition to discharging the remaining materials, the stones and water shall be poured into the trembling cylinder, the machine shall be started to rotate, and the mortar stuck on the cylinder shall be washed clean and then discharged. There shall be no accumulated water in the barrel to avoid rusting of the barrel and blades. At the same time, the dust accumulated outside the mixing drum shall be cleaned to keep the machinery clean and in good condition.
6、開機后，經常注意攪拌機各部件的運轉是否正常。停機時，經常檢查攪拌機葉片是否打彎，螺絲有否打落或松動。
6. After startup, always pay attention to whether all parts of the mixer operate normally. During shutdown, always check whether the blades of the mixer are bent and whether the screws are fallen or loose.
7、下班后及停機不用時，應拉閘斷電，并鎖好開關箱，以確保。
7. After work and when the machine is not in use, switch off the power and lock the switch box to ensure safety.
以上就是使用全自動攪拌車應遵守的操作規范，想必大家在以后的使用中會更加小心謹慎了，想了解更多資訊么？請繼續關注我們http://www.bflrsn.cn。
The above are the safety operation specifications that should be followed when using the fully automatic mixer. I think you will be more careful in future use. Do you want to know more? Please continue to follow us http://www.bflrsn.cn 。
