混凝土攪拌車滾筒清洗要注意什么?
1、混凝土攪拌車在施工現場卸料完畢后,應立即用拌和車隨帶的軟管沖刷進料斗、出料斗、卸料溜槽等處,鏟除粘附在車身遍地的污泥及混凝土。在回來拌和站的途中,應向拌和筒內注150---200L水以清洗筒壁及葉片粘結的混凝土殘渣。
1. After the concrete mixer is unloaded at the construction site, the hose accompanying the mixer shall be used to flush the feed hopper, discharge hopper, discharge chute, etc. immediately to remove the sludge and concrete adhered to the vehicle body. On the way back to the mixing station, 150-200l water shall be injected into the mixing drum to clean the concrete residue bonded to the drum wall and blades.
2、混凝土攪拌車每天作業完畢后,司機應負責向拌和筒內注入清水并高速(14—18轉/分)旋轉5—10分鐘,然后將水排去,以確保筒內清潔。用高壓水清洗拌和筒各個部分時,應注意避開儀表及操縱桿等部位。壓力水噴嘴與車身油漆外表間的間隔不得小于40厘米。
2. After the daily operation of the concrete mixer truck, the driver shall be responsible for injecting clean water into the mixing drum and rotating at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure the cleanness of the drum. When cleaning all parts of the mixing drum with high-pressure water, pay attention to avoid instruments, control rods and other parts. The interval between the pressure water nozzle and the painted surface of the vehicle body shall not be less than 40cm.
3、鏟除混凝土攪拌車拌和筒內外積污及殘存的混凝土渣塊時,以及在機修人員進入筒內進行檢修和焊補作業時,需先關閉轎車發動機,使拌和筒完全停止滾動。在機修人員進入筒內作業期間,需要確保混凝土攪拌車拌筒內通風良好,空氣新鮮,無可然氣體及有害塵埃,氧氣供應充足。在筒內運用電動工具操作時,操作人員需要有良好的絕緣保護。
3. When removing the dirt and residual concrete residue inside and outside the mixing drum of the concrete mixer, and when the mechanical maintenance personnel enter the drum for maintenance and welding repair, it is necessary to turn off the car engine first to stop the rolling of the mixing drum completely. During the period when the mechanical maintenance personnel enter the drum for operation, it is necessary to ensure that the mixing drum of the concrete mixer is well ventilated, the air is fresh, there is no combustible gas and harmful dust, and the oxygen supply is sufficient. When using electric tools in the cylinder, the operator needs good insulation protection.
4、混凝土攪拌車作業時,不得將手伸入旋轉的拌和筒內,禁止將手伸入主卸料溜槽和加長卸料溜槽的銜接部位主動,主動上交拌和車在作業時應注意什么以免發生事故。
4. During the operation of the concrete mixer truck, do not put your hand into the rotating mixing drum, and do not put your hand into the connecting part of the main discharge chute and the extended discharge chute. Take the initiative to hand it over to the mixer truck. What should be paid attention to during the operation to avoid accidents.
以上就是混凝土自上料攪拌車廠家給大家分享的主要內容,更多的精彩內容請大家繼續關注我們:http://www.bflrsn.cn
The above are the main contents shared by the concrete self loading mixer manufacturer. Please continue to pay attention to us for more wonderful contents: http://www.bflrsn.cn
下一篇:自動混凝土攪拌車的高噪聲是怎么回事?上一篇:攪拌車如何更換液壓油?