混凝土攪拌機皮帶松了會有什么影響？
我們對中科聚峰混凝土攪拌機生產中的不旋轉問題進行了明確的分析，首先考慮了嚴重的超載問題，其次考慮了攪拌葉片或側葉片與箱體內壁之間存在大量的異物。另一個原因是電機皮帶太松了。小型混凝土攪拌機的攪拌軸超過了正常的工作負荷，會導致攪拌軸旋轉緩慢。如果負荷太大，攪拌軸就會停止。這種情況也會導致混凝土攪拌軸停止轉動或轉動緩慢。
We have made a clear analysis of the non rotation problem in the production of Zhongke Jufeng concrete mixer. Firstly, we have considered the serious overload problem, secondly, we have considered that there are a large number of foreign matters between the mixing blades or side blades and the inner wall of the box. Another reason is that the motor belt is too loose. The mixing shaft of small concrete mixer exceeds the normal working load, which will cause the mixing shaft to rotate slowly. If the load is too high, the mixing shaft will stop. This condition will also cause the concrete mixing shaft to stop rotating or rotate slowly.
攪拌槳葉或側槳葉與罐體內壁之間的較大異物也會導致攪拌軸停止。由于混凝土攪拌機的攪拌葉片之間或混凝土罐體的側壁與罐體內壁之間有較大的間隙，可能會捕獲異物。如果小型混凝土攪拌機的混凝土傳動帶過松，也會導致混凝土攪拌機軸旋轉緩慢或停止轉動，電機傳動帶過松，導致傳動功率不足。
Large foreign matters between the mixing blade or side blade and the inner wall of the tank will also cause the mixing shaft to stop. Due to the large gap between the mixing blades of the concrete mixer or between the side wall of the concrete tank and the inner wall of the tank, foreign matters may be caught. If the concrete drive belt of small concrete mixer is too loose, it will also cause the concrete mixer shaft to rotate slowly or stop rotating, and the motor drive belt is too loose, resulting in insufficient transmission power.
那么如何解決小型混凝土攪拌機停止轉動，混凝土攪拌機超載，攪拌軸停止轉動的問題，只需調整進料量，排出多余的物料，降低攪拌軸的轉動負荷。當物料附著在側葉片和內壁上時，攪拌軸停止前總會有尖銳刺耳的摩擦聲。此時應立即停止檢查，人工清除異物，并調整小型混凝土攪拌機攪拌葉片或側葉片與箱體內壁之間的間隙。如果混凝土攪拌機的混凝土輸送帶太松，只需在停止后調整混凝土攪拌機的混凝土輸送帶的張力即可。
So how to solve the problems of small concrete mixer stop rotating, concrete mixer overload, mixing shaft stop rotating, just adjust the feed quantity, discharge the excess materials, reduce the rotating load of mixing shaft. When the material is attached to the side blade and the inner wall, there will always be sharp and harsh friction sound before the mixing shaft stops. At this time, the inspection shall be stopped immediately, the foreign matters shall be removed manually, and the gap between the mixing blade or side blade of the small concrete mixer and the inner wall of the box shall be adjusted. If the concrete conveyor belt of the concrete mixer is too loose, the tension of the concrete conveyor belt of the concrete mixer can only be adjusted after stopping.
以上是中科聚峰混凝土攪拌機廠家為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://www.bflrsn.cn
The above is the relevant content introduced by the manufacturer of Zhongke Jufeng concrete mixer. To learn more, please visit the website: http://www.bflrsn.cn
