攪拌車上裝應該了解的7個小常識
全自動攪拌車實際上在運行時還是存在一定的危險系數的，因此需要操作人員來提前進行充足的了解，下面全自動攪拌車廠家就來講講攪拌車上裝應該了解的7個小常識。
In fact, there is a certain risk factor in the operation of the full-automatic mixer truck. Therefore, the operators need to know enough in advance. Here, the manufacturer of the full-automatic mixer truck will talk about seven common knowledge that should be understood when loading the mixer truck.
一、攪拌車拖輪是干什么的？
1、 What is the tug of the mixer?
攪拌車拖輪是個軸承，用這個把罐體支撐起來，它是與攪拌車是一體的，輔助攪拌。
The tug of the mixer truck is a bearing, which is used to support the tank. It is integrated with the mixer truck to assist mixing.
二、攪拌車液壓泵怎么換油？
2、 How to change the oil of the hydraulic pump of the mixer truck?
一般不建議自己換，直接到售后點找人事更換，而且使用的油必須符合要求，不然對設備損害很大，使用壽命也會大大縮短，應更換合理標號的液壓油。
Generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find professional personnel to replace it. Moreover, the oil used must meet the requirements, otherwise the equipment will be greatly damaged and the service life will be greatly shortened. The hydraulic oil with reasonable grade should be replaced.
三、攪拌車罐體填充率跟罐體的傾角有什么關系？
3、 What is the relationship between the filling rate of the mixer tank and the inclination of the tank?
目前攪拌車傾角在12度左右，填充率為63%左右。傾角不好測量，填充率也很難計算。目前銷售攪拌車都以有效攪拌容積為準。
At present, the inclination angle of the mixer truck is about 12 degrees, and the filling rate is about 63%. The inclination angle is difficult to measure and the filling rate is difficult to calculate. At present, all mixer trucks sold are subject to the effective mixing volume.
四、攪拌車罐不轉，轉開了沒力而液壓油從油箱加油口噴出來是什么原因？
4、 What is the reason why the tank of the mixer truck does not rotate, and the hydraulic oil is sprayed out from the oil tank filler after it is turned without force?
液壓一個進一個回，進沒力可能是油泵封閉部分壞了。回油沖，可能是油泵封閉腳墊壞了，可以換個腳墊試試。
The hydraulic pressure goes in and out one by one. It may be that the sealing part of the oil pump is broken. The oil return is flushed. It may be that the sealing foot pad of the oil pump is broken. You can try a new one.
五、攪拌車攪拌桶的轉速是多少？
5、 What is the rotation speed of the mixer drum?
進料時攪拌筒的轉速：6—10轉/分；攪拌時攪拌筒的轉速：6—10轉/分。
Speed of mixing drum during feeding: 6-10 rpm; Speed of mixing drum during mixing: 6-10 rpm.
六、8-12方的攪拌車進料口到地面距離是多少？
6、 What is the distance from the feed port of the mixer truck of 8-12 square meters to the ground?
一般8-12方的攪拌車整車高度大概在3.8米左右，進料口距離地面就有3.5米左右，具體情況取決于不同的車型。
Generally, the height of 8-12 square mixer truck is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, depending on different models.
七、攪拌車怎么清洗罐？
7、 How does the mixer clean the tank?
攪拌車配的水箱，每次卸完料后就應該將水放入罐體內，在返回時攪拌行駛，到攪拌站后再將水排出接料。罐體外表應該在水箱加水時即可順便清洗。當然也可以直接用水箱內的水清洗。如果水泥漿已經凝固，罐體內找的清罐，外表凝固用草酸刷洗就行了。
For the water tank equipped with the mixer truck, the water shall be put into the tank after unloading each time, and the water shall be mixed and driven when returning. After reaching the mixing station, the water shall be discharged to receive the materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has been solidified, find a professional cleaning tank in the tank, and brush the surface with oxalic acid.
攪拌車上裝應該了解的7個小常識相關內容就是這樣了，您對此有什么想了解的問題可以隨時來咨詢我們http://www.bflrsn.cn！
That's all about the 7 common knowledge you should know when loading the mixer truck. If you have any questions about this, please feel free to consult us http://www.bflrsn.cn ！
下一篇：攪拌車駕駛時要注意許多類難題了上一篇：二手自上料攪拌車的購買技巧
